My buttons and triggers turned much less and fewer responsive over time. Then a set off swap tweaked and allowed half vary in all positions. Fed up, I seemed up a disassembly information and commenced rigorously separating the shell. From what I keep in mind the fasteners are both T5 or T6 w/safety pins. First I cleaned the set off switches on the again half, then the buttons and set off meeting, then the entire entrance half. After reassembly all features are 100% responsive though the triggers have a bit stick when first pressed. I feel that’s simply from residue from the alc swabs. I by no means was in a position to repair my concern with the paddles, the nub that contacts the precise button isn’t giant sufficient so the paddle hits the again of the controller earlier than urgent the button. I’ve a plan to drop a little bit of solder on the nubs to offer the paddles a bit extra elevation away from the case. submitted by /u/South-Coat4178 |